Place
the plate under the center joints where the tiles meet.
Let the thin steel wire loop of the plate emerge between
the tiles. While holding the machine in place, press
down on the plunger securing the tube tightly over the
center of the tiles.
Allow
the Marble Plane to sit for approximately 20 - 40 minutes
over tile joints before removing. As the setting material
hardens, no shrinkage can effect the tile. Removal time
depends on the amount of water absorbency of the tile
and floor, as well as air temperature. After removing
the machine, the exposed wire loops must be cut and
removed.
Marble
Plane Set includes: 24 Marble Planes and 100 Wire plates.
Marble Plane and wire plates are made of rust-free stainless
steel and will not leave marks on tile or marble.
1. Insert wire plates between
joint during installation.
2.
Press down on plunger and hook into wire plate. Release plunger
slowly and set the Marble-Plane gently on tile surface.
3.
Marble Plane must go between the center of the tile joints,
NOT at the corners.
4. After 45
minutes to an hour, the Marble Plane may be removed to continue
with installation of tile/marble. Be sure not to remove the
wire plates, for they must remain in place.
5. Wait at least
24 hours before cutting and pulling out wires.
